Just replaced the seals on my 57 and didn't have the problem and I didn't
hone them.
My only problem is getting the pipes to stop leaking where they enter the
master cylinders.
Jeremiah
-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of Gary Nafziger
Sent: Thursday, April 07, 2011 5:25 PM
To: triumphs at autox.team.net
Subject: [TR] master cylinder rebuild
I've installed new rebuild kits in my 1960 tr-3 master cylinder's (clutch
and
brake) and find when i push in the plungers they won't spring
back..............just stick. One is worse than the other but neither seems
serviceable. I've honed both cylinders and due to the age i'd imagine
they've
been honed before over the years so I'd assume if any problem existed that
they'd be too loose if anything. I've measured the inside dimensions and
the
cylinders are 75's so I am pretty sure I have the correct kit.
My question is whether others on the list have had the same problem. I'm
thinking the old springs inside might be weak and new springs might correct
the
problem?
thanks
gary n.
_______________________________________________
Triumphs at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Manage your account:
http://autox.team.net/mailman/options/triumphs/jeremiah at curryclan.net
|