List,
I'm attempting to fit a new Grant piston ring set to a set of used, AE brand,
86mm, TR4 pistons.
In attempting to assemble the 3 piece oil control ring, I found that the
expander-spacer is too long, preventing the installation of the two other rings
of this set. The expander-spacer also does not fit the bore. No big surprise,
but I thought I'd check it in the bore as well as on the piston. All other
rings, compression and oil, fit the 86mm std. bore with a .012 gap.
I tried the oil control ring set from the second Grant ring set with the same
result.
The (used) pistons are British made AE, 4 ring. They were installed with the
current liners as the engine came to me. There is virtually no wear in piston
or liner. The liners were honed to break the glaze.
I have on hand two sets of Grant rings for these pistons.
A few questions for the List:
1. Has anyone experienced this problem with Grant ring sets?
2. Should I just forget about the expander ring set and use a single, plain oil
ring above the wrist pin?
3. Should I use two standard oil rings, one above and one below the wrist pin
by using an additional ring from the second ring set?
Any insights/comments welcome.
Ed Woods
|