That is what I thought. I went ahead and bought it for $90.00, I can
re-engineer or make the brackets. Many thanks to all who responded that
helped me to figure out just what I was looking at.
Bill
Bill Beecher
'58 TR-3A TS30766L "Tarbaby"
www.triumphowners.com/1566
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: Joe Laurito [mailto:trglory at verizon.net]
Sent: Sunday, March 27, 2011 7:17 AM
To: 'Geo Hahn'; wbeech at flash.net
Cc: triumphs at autox.team.net
Subject: RE: [TR] TR3 Rear Seat Part number Question
The seat cover is for a TR3a with a sloped rear floor; the irons are for a
TR3. They are not compatible.
Joe Laurito
-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of Geo Hahn
Sent: Saturday, March 26, 2011 10:17 PM
To: wbeech at flash.net
Cc: triumphs at autox.team.net
Subject: Re: [TR] TR3 Rear Seat Part number Question
On Sat, Mar 26, 2011 at 3:54 PM, <wbeech at flash.net> wrote:
> There is a rear seat kit on eBay for a TR3... Might anyone know what
> commission range this fits.
That rear seat has the curved front edge... some had a straight front edge
with more squared corners. My TS47905 has a curved front edge though I
cannot say whether that is correct.
http://i.ebayimg.com/00/$(KGrHqR,!j!E1NPEVRk1BNhW0c647Q~~_12.JPG
Also -- my brackets are simpler than those -- again, can't swear they are
original but suspect they are.
http://i.ebayimg.com/00/$(KGrHqJ,!lwE2FT5o3qGBNhW1F,cUQ~~_12.JPG
Geo
|