WD40 and patience. I think I used a small flat screwdriver that was worn so
it would not cut into the rubber to work the grommet-like bushings into
place.
Bill
Bill Beecher
'58 TR-3A TS30766L "Tarbaby"
www.triumphowners.com/1566
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of G.D. Huggins
Sent: Monday, March 21, 2011 3:21 PM
To: triumphs@autox.team.net; RedRiverTriumph@yahoogroups.com
Subject: [TR] Install Wiper Motor Bushings
All,
Any tips for installing the three cylindrical rubber bushings into the wiper
motor mount?
Their diameter is much larger than the hole, and I'm having a hard time
imagining them fitting through.
Cheers,
Guy D. Huggins
1965 Triumph TR4A
CTC 63569LO
Online project diary at http://www.genfiniti.com/triumph
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Manage your account:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|