List,
One thing I noticed while restoring my TR4A IRS was that the lever arm shock
actually limits the downward travel of the swing arm. I am not sure if everyone
realizes this. The way I realized this was during my rear suspension assemlby,
I had installed the spring first, then the half shaft. When I released the
spring compressor on the rear spring, the half shaft locked up. Upon closer
inspection, the universal joints were locked up due to the excessive angle of
the half shaft. So, I installed the lever arm shock and the universal joints
could now rotate smoothly.
My point is anyone considering this conversion needs to figure out a way to
limit the downward travel of the swing arm as part of the upgrade. I suspect
that the damage people see after this upgrade is the bottoming out of the swing
arm being absorbed by the upper cross member. I think the real danger is what
is happening to the universal joints. If you go thru a deep enough pot hole or
what ever, the damage could be significant.
I think that anyone who has installed tube rear shocks should lift the rear of
their car off the ground and try rotating the rear wheels. If you feel ANY
resistance, don't drive the car until you figure out a way to limit that
downward swing arm travel.
Dave Connitt
'67 TR4A
http://home.fuse.net/davestr4a
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|