Angelo
you could tap it out to a 7mm x 1mm size.
its just a hair bigger
Frank
________________________________
From: Angelo Graham <agraham at execulink.com>
To: triumphs at autox.team.net
Sent: Wed, February 23, 2011 2:30:00 PM
Subject: [TR] TR3 brake caliper question.
Hello List:
Just have a question about repairing a stripped thread on a Girling caliper. I
have the caliper that uses the triangular metal tabs to hold the pads in the
caliper.
The top small 1/4" in. bolt hole that holds the bolt for the tab is stripped. I
thought of opening the hole out to accept a 5/16" NF bolt, but not sure about
this as the hole is close to the center line/split of the caliper. Any problems
with opening this hole out?
The hole is not stripped too badly. Would it accept a 1/4" coarse tap? Even
using a Heli-coil would require opening the hole out to at least 9/32".
Any experiences with this repair?
Thanks for any help with this.
Angelo Graham
_______________________________________________
Triumphs at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation? $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Manage your account:
http://autox.team.net/mailman/options/triumphs/yellowtr3 at yahoo.com
|