New PRODUCTION RUN of this kit PENDING at the end of the
month.................................................
We supported the production of Uncle Jack's original conversion design and
helped with marketing. We ran a couple of production lots for Uncle Jack and he
distributed.
Following Jack's passing, son Tony handed off the entire project to us.
The we produced a couple of production runs....Bob Danielson and Paul Rego
pointed out a few things about the kit when we sent them samples of the kit.
Great guys to work with, especially when we had no experience with the original
design and an actual installation
Over a period of time I acquired MIATA seats and pieces to evaluate the design.
Finally, we held a design review with all of the pieces in place. We discovered
what we think is an error in measurement leading to difficulty in installation,
as we had been advised.
The offending part has been redesigned and a new production run has been
scheduled for the end of the month. So we are running about 25 more kits and
have a backlog of about 12 orders. If you want a kit, please send me your
interest and I put you on the list and I will pass it to Sean.
We would produce 50 kits, but we may see opportunities for further improvements
and perhaps commonalities leading to a kit for the TR4A and TR4......GETTING
TIME to do the ultimate kit is difficult, but we would like to work at.
Thanks to some mentoring by BOB and PAUL, along with some patience, we have an
improved kit with the possibility of further progress.
The feedback we get on the installation and use of the Miata seats is very
positive and makes this a very worthwhile and satisfying project
Joe Alexander n197tr4 at cs.com
Sean Alexander
|