Apologies to Bob, it was your suggestion that solved the problem. Too many
emails today...
Thanks to all,
Bill
-----Original Message-----
From: wbeech@flash.net [mailto:wbeech@flash.net]
Sent: Saturday, January 22, 2011 4:04 PM
To: 'Chris Simo'; 'list Triumph'
Subject: RE: [TR] [British-cars] Lucas Starter Squeal
Chris,
Congratulations, you are the 'Genius du Jour'. I reached down and put my
hand on the stalled starter to see if it was hot or I could feel anything
rattling inside and it took off spinning as if there were no spark plugs.
Even though it was tightly bolted up and I could not discern that it moved
at all.
I am guessing that the rebuilder got paint on the end of the mounting
surface and it was creating the insulation that was preventing a good
ground.
Live and learn!
MANY thanks to everyone who responded with excellent suggestions, I tried
them all.
Bill
Bill Beecher
'58 TR-3A TS30766L "Tarbaby"
www.triumphowners.com/1566
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Chris Simo
Sent: Saturday, January 22, 2011 2:23 PM
To: list Triumph
Subject: Re: [TR] [British-cars] Lucas Starter Squeal
I've had the brush issue myself. the car just would not start -- I thought
it was a tired battery. Bought a new one and it did not do the trick. --
being a bit naieve - I went and bought the biggest battery that would fit in
the hole. It would still barely turn but did get it started - likely cause
the engine had low compression....
I tore into the starter and found one of the brush holders had broken - as I
had to be on the road early the next morning - I had a brass angle bracket
that I used to bolt the thing together to get me going. 10 or more years
later -- I still haven't gone back and fixed it properly...
I will address it when I rebuild the engine -- most times when I start the
car - I get this wraaang noise after it's cranked - I assume the starter
drive gear is not retracting fast enough... If the noise comes after it's
started - could be your rebuilder used grease to lube the sliding assembly
-- that will get cha...
Chris
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Manage your account:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|