Darrell,
Try placing the pin in the hole of the handle and have it slightly protrude
into the shaft hole in the handle before slipping it onto the shaft. With
one hand holding the panel back against the spring and with a finger from
the other hand on the end of the pin as you install the handle you'll feel
the pin drop into the hole in the shaft. Once there use something larger
than the pin to push it through the shaft. Bob's your Uncle.
JVV
----- Original Message -----
From: <TR250Driver@aol.com>
To: <triumphs@autox.team.net>
Cc: <6pack@autox.team.net>
Sent: Monday, January 17, 2011 1:26 PM
Subject: [TR] TR6 Inside Door Handle Installation
> Hey Guys,
> I have about an hour in it now with Beverly helping. No success, we just
> gave up. Trying to get that little barrel into both holes with the
> springs
> behind the door is impossible!!!!! I have done this before but I think I
> always coped out and took the springs out. Then it is just very
> difficult.
> I have the door glass replaced, the panel back on and all I need is the
> handles back on.
>
> I hear there is a special tool for this. Anyone know where I can buy
> one?
> Any tips on how to make this job possible? I tried using needle nose
> vise grips & needle nose pliers.
>
> Thanks,
> Darrell
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|