triumphs
[Top] [All Lists]

[TR] Fwd: Re: Fwd: TR3 O/D Wiring question

To: triumphs@autox.team.net
Subject: [TR] Fwd: Re: Fwd: TR3 O/D Wiring question
From: cfmtr3a@verizon.net
Date: Sun, 05 Dec 2010 10:18:31 -0600 (CST)
Thanks Randall -

However...
The diagram you reference matches the right side of my image which is the 
wiring diagram. The two harnesses I have do not match that but for the 
wires to connect would have to be similar to the left side image and that 
doesn't look right to me. the only variation would be that W1 & W2 could 
be swapped. It looks like the relay would always be 'hot'.

Revised schematic at:
http://i1001.photobucket.com/albums/af136/cfmtr3a/Information%20Items/ODWiringSchematicv2.jpg
 
I added a representation of the wiring harness layout.  You can see what I 
mean about the brown & white seem to go to the same place.  
The 'device boxes' match the left side of my diagram.

As you may remember, I am adding a Lucas 25a fused line between A (Control 
Box to Ammeter) to an Accessory Plug circuit. See:
http://i1001.photobucket.com/albums/af136/cfmtr3a/fog-spotschematicv2.jpg
Do you see any reason that I cannot reroute the C1 feed to that 
line/connection? 
I can add a piece in the new fog/spot/acc harness to where the o/d harness can 
connect to it. That would be another case of cleaning up the spaghetti... 
(Your OD diagram has the C1 going to A)

I show that the o/d solenoid comes off of C2. do you piggyback a ground 
connection from that terminal? That looks like what you have but just 
confirming..

Thanks again.

----- Original Message ----- 
From: "Randall" 
To: 
Sent: Saturday, December 04, 2010 11:56 PM
Subject: Re: [TR] Fwd: TR3 O/D Wiring question


>> There is a descrepancy between what is on all three of my
>> wiring diagrams and how the harness is set up.
>
> If you check the diagram at
> http://tinyurl.com/l9jkj7
> I think you will find that it matches your harness (and the original 
> harness
> on TS39781LO). It works just fine.
>
> However, I added a in-line fuse between the ammeter and C1, and also a 
> diode from C2 to ground. 
<SNIP>
>
> I used a MDL-8 8 amp "slow blow"  
<SNIP>.
>
> The diode greatly extends the life of the relay. It's just an ordinary 1
> amp 100 volt power diode like from Radio Shack. Here's a shot of it
> installed on TS39781LO http://tinyurl.com/2dcppeo
<SNIP>
> -- Randall
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>