Yesterday I tried to remove the little pins on the fork that actuates the throw
out bearing and could not get them off. I was using a bench vise and put all
the pressure I could. It got me to thinking.........which way do they come
off? I assumed they push out toward the outside of the fork so I was pushing
from the inside. However on close inspection I'm thinking maybe they should be
pushed toward the inside to get them off?
If they are installed from the inside pushing them out.........then they must
have been peened over on the outside since mine have that look on the outside.
They are not worn as bad as they could be so I'm thinking of leaving them as
they are rather than ruining something.
just curious
gary n.
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|