I'm not familiar with the 3 but it sounds like you are trying to fit the
rubber mounting things into holes that visually appear to small? I recently
did this on my 10 so just guessing the concept is similar.
I squeezed the rubber by it's sides and put one end in the slit in the middle
of rubber mount. Then I used a small blade scre driver to push (force) the
opposite side. Then working the rest in with same screw driver.
Don't let that scree driver slip! Tom
Sent from my iPhone
On Nov 12, 2010, at 8:17 AM, "Carl TR" <cfmtr3a@verizon.net> wrote:
> Short of cutting them at the 'recess' and using the fastener to sandwich
them in, I can't get the rubber bits to get into hole...
>
> C
>
> ----- Original Message ----- From: <Dave1massey@cs.com>
> To: <triumphs@autox.team.net>
> Sent: Friday, November 12, 2010 7:52 AM
> Subject: Re: [TR] Wiper motor mount
>
>
>> In a message dated 11/11/2010 8:56:23 PM Central Standard Time,
>> cfmtr3a@verizon.net writes:
>>> Ok, I give... is there a secret to mounting the three rubber bushings
>>> for the windshield wiper motor?
>>>
>>
>> Well, first you insert the rubber bits into the mounting bracket and then
>> insert the spacers.
>>
>> Is that the technique you are using?
>>
>> Dave
>> _______________________________________________
>> Triumphs@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $11.47
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Manage your account:
http://autox.team.net/mailman/options/triumphs/cfmtr3a@verizon.net
> _______________________________________________
> Triumphs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Manage your account:
http://autox.team.net/mailman/options/triumphs/tbe749@aol.com
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|