I just remembered that on the car with the unfinished carpet to the bottom of
the rear panel, we fabricated
new clips for the bottom of the panel which we attached with rivets to the back
panel (have to remove the vinyl to do this)
The clip comes down normally then there about an inch of recess in the bracket
then it comes forward again to
screw into the metal floor. This was on two post 60,000 cars. Nothing was done
to the brackets on the car with the
finished seam on the carpet where it meets the back panel.
Hope this helps.
Tom
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|