I asked this question below - cannot find the response (if there were any)
and searching the archive came up empty.
When rebuilding the engine for the '3 project, I used a plug in the breather
pipe block hole. Forgot to pull it out before installing the engine. Now
I am trying to install that pipe and cannot figure out how to get the plug
out.
There isn't enough room to get a drill or any other tool. Any suggestions?
I have a right angle drill but there isn't even clearance for that.
What about a 1" hole in the wheel well to access it and then plugging with
the 1" plug like on the firewall? Frustrating afternoon.
Thanks
Carl
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|