taking apart tr-3 motor. found that big end rod bearings are .010 over.
taking
off the main bearing front and rear bearing/seal I find no notation of .010
but
do find the number 0.254 MM above it another number that i think is a part
number.
just curious. I'm assuming that the main bearings are standard even though
there is not a "standard" marking on the bearings. surely they aren't 0.254 mm
over? Is it normal to go over on the rod bearings and leave the main bearings
standard?
thanks
gary n.
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|