Hi All,
I have a question about the cam bearing and inserting the set screws.
I had a machine shop insert the cam bearings for me, and I believe
they did the job correctly as far as lining up the holes (mostly).
The problem is that for all 3 bearings the cam bearing slightly
covers the set screw holes such that I have a crescent moon shaped
blockage. So what do I do now? I am afraid that if I insert the
set screws that I will mar the bearings. I thought about drilling
out the blockage, but even though it's minor, I'm worried that they
might travel a bit later and end up blocking one of the other holes.
Any suggestions?
Thanks,
Todd Richmond
Fort Collins, Colorado
1959 TR3A TS54425L
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|