A follow-up question:
The radiator end of the larger pieces has a crimp that implies that it is
bent forward. The question is: does it bend just to lay against the front
of the radiator or does it bend about 115degrees so that it rests against
the side of the radiator? That would mean the center piece is wider than
the radiator and has to bend away from the front to attach to the side
pieces. Sure wish I could find the center piece - that would probably
answer the question.
If anyone has an image of the mounted shroud - that could also be helpful.
Thanks again
Carl
----- Original Message -----
From: "Carl TR" <cfmtr3a@verizon.net>
To: "Triumphs" <triumphs@autox.team.net>
Sent: Sunday, August 01, 2010 12:30 AM
Subject: [TR] TR3 Radiator Shroud question
>I am missing the piece that goes across the top of the radiator. Could
>someone please measure the overall length; the height at each end and at
>the center. I think it mirrors the top of the radiator, but not 100%
>sure.
>
> Thanks
> Carl
>
>--------------------------------------------------------------------------------
> Carl - Tampa
> 1961 TR3A TS81802LO
> Body Off Restoration
> Completion Date: NATC 2010 (Jekyll Island, GA)
> http://mysite.verizon.net/cfmtr3a/
> (Photos updated 5/18/10)
>
> _______________________________________________
> Triumphs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/triumphs/cfmtr3a@verizon.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|