You are looking at the page for the TR4. TR3's just have the one type of
bumper/buffer that wraps around the rear axel, Moss p/n 674-580, you will
need two of these. The installation of them is what the email you found is
referring to.
I may have a picture or two, I will send it off-line.
Bill Beecher
'58 TR-3A TS30766L "Tarbaby"
www.triumphowners.com/1566
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
They list #81 Bump rubber (on body), #82 rebound rubber (on frame) and #85
Buffer (on ???) I don't have a clue. I can guess on the bumper on the
frame
- I see a fastener on the frame but other than that I'm lost. Anyone have
pics or can help me out?
I found this in the MY archives from 2006 and still shaking my head.
> I am looking at installing the new rubber bumpers on the rear axle.
> Since they don't streach far enough to clear the bearing flange the
> only way I can see to install them is to cut them and tie them with
> safety wire (or zip ties).
> Before I pass the point of no return I ask: "Am I missing something?"
I don't think so. That's the way the originals went on, too.
Randall
Thanks in advance,
Jack 1959 TR3A
Philadelphia, PA
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|