Brad,
Assuming you are talking about the eye part and not the post, the answer is
a definite YES! All you have to do is locate the part that has the tabs
sticking out and turn it so that the metal piece is against a solid surface
and the fabric is pointing up. A couple of raps with a rubber mallet will
make the tabs cut through the fabric without bending them.
Afterwards, you can position the other metal (slotted) piece onto the tabs
and bend them over using a tack hammer.
Finally, cut the hole in the center of the fastener with anything that will
do the job, (Awl, Phillips screwdriver, etc).
That is how I installed the fasteners on the front of my Spitfire tonneau
cover. They work much better than the large eyes that came from the
factory.
Joe
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Brad Kahler
Sent: Monday, June 07, 2010 12:42 PM
To: Triumphs
Subject: [TR] lift-a-dot
I need to replace the straps on the top frame of my TR4 where each
strap has one Lift-A-Dot fastener at the back end.
The question is, is it possible to install new Lift-A-Dot fasteners
without spending $75 for the installation tool?
Thanks!
Brad
1963 TR4
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/triumphs/spitlist@cox.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|