While I went with the AAW harness for my TR6, some of the tools/tips ;listed
here (http://tr6.danielsonfamily.org/Wire_Harness_1.htm) might help. You
should also go to British Wiring (http://www.britishwiring.com) and check
out their supplies and tools like the
bullet crimper #TT85 and their bullet pliers #SSC1.
(http://www.britishwiring.com/CAT28_29.PDF) Neither tool is cheap but they
do make working with bullets a whole lot easier.
Bob
Bob Danielson
1975 TR6 running with
Throttle Body Injection
Toyota 5 Speed
Nissan Diff & CVJs
http://tr6.danielsonfamily.org
--------------------------------------------------
From: "davewillner" <dwillner@ptd.net>
Sent: Thursday, May 20, 2010 8:53 AM
To: <triumphs@autox.team.net>
Subject: [TR] tools to correctly install a TR3A harness
> What tools are recommended to do an "original" looking wireing harness
> replacement job easily, getting a new cloth covered wiring harness and
> want to
> make sure it is done correctly and looks pretty original...done bikes, but
> never have done a car before...Thanks
>
> Dave Willner
> Stroudsburg, PA
> 59 TR3A
> 70 MGB
> 70 BSA Victor Special
>
> _______________________________________________
> Triumphs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/triumphs/75tr6@tr6.danielsonfamily.org
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|