I finally got around to bolting all back together from chasing that bottom
end rattling noise I was looking into back in Feb. (lucky for me my two old
XS650's are keeping me company).
The thrust washers were changed out using a .005 over, and a standard. The
new end float measured in at .004" (from .011"). The dog bolt which was
found loose was torqued at 140 foot/lbs.
Happy to say, there is no longer any noises from down there. Now I just got
to fit the nose back on and away I'll go. That'll happen today.
Thanks all for the advise,
Ed (Hudson Valley NY)
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|