Ed: Standard size thrust washers should be 0.092" new.
Tom
----- Original Message -----
From: <popnglo@gmail.com>
To: <triumphs@autox.team.net>
Sent: Sunday, April 18, 2010 7:13 PM
Subject: [TR] TR3 Thrust washer thickness
> Does anyone know the nominal thickness of the crankshaft thrush washer? I
> removed both sides, and they measured ~0.086" each. The end float was
> 0.012". I plan on replacing with an oversized (0.005) and a standard.
> Copper showed on one side, grey on the other, for both washers.
> Ed (Hudson Valley NY
>
> _______________________________________________
> Triumphs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/triumphs/tom628@verizon.net
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|