npaul72464@aol.com wrote:
> Hi All,
>
> I'm in the midst of adjusting the valves on my 1958 TR3A and have run into a
> snag. They all adjusted fine till I got to #8 where there is no gap and no
> turning of the screw will give me any. I checked compression (for some
> reason) and there's 150 PSI in all 4 cylinders. I pulled the rocker shaft and
> the rocker and push rod look normal compared with all the others. I put a
> straight edge across all the valve springs and they're all the same height.
>
>
With the rocker assembly off the engine, did you turn the engine over a few
revolutions by hand? Did the offending pushrod move as you think it
should have?
mjb.
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|