triumphs
[Top] [All Lists]

[TR] Solid Copper Head Gasket for TR3

To: triumphs@autox.team.net
Subject: [TR] Solid Copper Head Gasket for TR3
From: Allan Reich <areich@telus.net>
Date: Mon, 15 Mar 2010 18:22:05 -0700
Greetings.
I have blown a number of head gaskets (at least 5) and have discussed 
this on the list over the last couple of years. The last one blew 
outside Eureka coming back from Triumphest .. this was on an engine 
rebuilt completely professionally.
A well trusted source has suggested that the new gaskets are built for 
83 - 87 mm pistons and can easily burn out, especially with 87 mm 
pistons, which I have.
He suggested a solid copper gasket, which he uses in his tr3/tr4 racing 
engines and suggest they may be the answer.
I have been on Gasket Works web site, and it seems to make sense. They 
also discuss at length the o-rings required.
What are the list's opinions on solid copper head gaskets? .. also on 
installing the o-rings? .. importance of specific 87mm sizing?
While it is apart, I am also planning to put in the 6 vane water pump 
and try and find a 185 long thermostat and take out my drilled out brass 
plug. Can't cover too many bases.
Thanks
Allan Reich
Vancouver, Canada
1960 TR3A - TS65713L (+O)

_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>