Bill,
If nobody has one, suggest you spend some time at a junk lot - you may find a
similar unit, even in a later model, that you can adapt.
I have found quite a few items in two wrecked MGs that work in my TR6 - they
both sourced many of their components from the same vendor.
Stan
----- Original Message -----
From: wbeech@flash.net
To: british-cars@autox.team.net, Triumphs@autox.team.net
Sent: Friday, February 5, 2010 10:23:56 PM GMT -05:00 US/Canada Eastern
Subject: [TR] Wiper motor Gear needed
Hello List,
Just got my wiper motor all running fine only to find out the nylon gear
that drives the cable is partially stripped. Works fine if the wiper are
flipped back from the windshield but not too good when in the correct
working position.
Anybody got a good one of these gears that you would wish to sell? This
model is the early TR3A, the gear wheel is about 2" in diameter, the numbers
on the gearbox case is 75296d, this number "130" is stamped onto the gear
wheel itself.
Thanks,
Bill
Bill Beecher
'58 TR-3A TS/30766 L (On the road in 2009!)
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $11.47
You are subscribed as stantr6@comcast.net
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $11.47
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|