As Bud says, don't take shortcuts with the brakes.
But the dustcover seal breach will allow water into where the piston slides
into and out of the caliper bore. Water will cause rust that can inhibit the
movement of the pistons and one piston will hang up causing a pad to drag
causing the brakes to heat up and compromise your stopping ability.
Ask me how I know.
Dave
-----Original Message-----
From: dorpaul <dorpaul@bellsouth.net>
List,
Would it be real bad if I were to install a dust cover for my TR3's caliper
brake piston which had a 1/2" tear in the rubber where it attaches to the top
grove in the caliper pot? (lifting up and under the skirt of the flat dust
cover allows me to see almost 1/2" of the piston's silver side)
Since it is only the dust cover that has this little 1/2" tear, it proably
is
ok...right?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|