Hi,
I am having trouble locating shims to adjust the end play in my distributor
drive. I read in the manual that I am supposed to stack a known thickness
spacer under the drive and measure the total clearance off the block and then
install the appropriate shim thickness to get to the nominal value. Not too
hard, but nobody sells the shims that I am aware of. Actually, I can't
remember removing any when I took it apart.
So, do it just buy some shim stock and make my own?
Thanks,
Dave Connitt
'67 TR4A IRS
http://home.fuse.net/davestr4a
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|