anyone know if theres a source for just the seal for the primary plunger on a
tr-6 brake master cylinder? I purchased a new re-build kit and while
attempting to strip the seal over the end of the plunger it split in half.
Hate to purchase a complete kit again simply for one seal. I probably did
make a mistake in that I stripped it over the biggest end of the plunger
rather than the pointed end which might have been easier.
thanks!
gary n.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|