As Randall already mentioned, I'd check the vertical link for
straightness. I had both bent on a TR4. If you have access to a lathe
chuck the screw end and bring the tail stock with a center near the
ball joint hole. Rotate by hand and the results will be obvious.
Allen
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|