I recall that I ended up cutting mine to get them to fit. Once installed,
you can't see the cut.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Ed Woods
Sent: Thursday, September 03, 2009 8:19 PM
To: triumphs@autox.team.net
Subject: [TR] Wiper motor mounting
List,
I've purchased a new wiper motor mounting kit which, of course, includes the
three rubber bushings that are supposed to occupy the three holes in the
steel
plate under the wiper motor. Same kit for TR3, 4, 250, 6 and probably
others.
Back in the days of Lucas and Lucas parts I can recall installing these
bushings w/o a whole lot of cussing. Well, today, the air was blue, but to
no
avail. All I managed to do was to scratch some new paintwork.
Has anyone on the list installed these bushings recently (recently as in non
Lucas)? What's the secret to installing them with a minimum of damage to
paint, tools and as little blood as possible?
TIA,
Ed Woods
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|