Hello List:
Once again, the wisdom of the list is required regarding a front
suspension rebuild, specifically the lower outer (trunnion) pivot.
The inner steel washers get a rubber sealing band around them,
correct? What about the outer paired steel washers - the flat one and
the collared one. These fit together. Do they get a rubber band
around them as well? The red manual mentions a "grease seal". Is this
the rubber band around these paired washers??
How important is the manual instruction on seating the splines on the
washers by tapping the lower control arms "out"?
Thanks for any help with this.
Angelo Graham
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|