Mark, I don't know the answer with certainty (regarding the Gunst
throw-out), but I'd certainly put pressure on the crank towards the
rear of the car to measure the "zero" position. Then you can have
someone push on the clutch for the other end of movement (or pry the
front pulley forward gently). Since everything is floating in oil it
shouldn't take too much pressure to move the crank fore and aft.
- Tony Drews.
At 02:50 PM 8/10/2009, Mark Hooper wrote:
>Hello all:
>
>I have decided to try measuring the crankshaft end float on my TR6. I
>purchased a magnetic mount and a dial gauge. However, a question comes
>to mind: I have the Gunst throw-out bearing setup (working nicely BTW).
>It has a permanent pre-load given by a spring. Will this cause the crank
>to shift the "zero" position that I obtain by pushing the crank pulley
>rear-ward? Will I need an assistant to keep pressure on the pulley to
>defeat the spring, or is friction too high for this to account for much?
>
>Cheers,
>
>Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|