triumphs
[Top] [All Lists]

[TR] TR4A Scuttle Vent Installation

To: triumphs@autox.team.net
Subject: [TR] TR4A Scuttle Vent Installation
From: Ben Zwissler <bjzwissler@gmail.com>
Date: Wed, 05 Aug 2009 23:04:17 -0400
Help!  I'm looking for hints on how to install the scuttle vent seal and 
actuating rod on my TR4A.  With the seal in place, it seems impossible 
to get the screws in.  Also, I can't find any orientation that allows 
the actuating rod to be installed when after the vent is installed.  
Does it have to be installed before the vent is installed?  Does the end 
of the rod enter from the "inside" or the "outside"?  (Appears to be 
from the "inside" (from center of car going towards right fender).  
Thanks for any help, I've spent too much time on trial and error on this 
already so I'm hoping someones BTDT.

Ben......

-- 
Ben Zwissler
bjzwissler@gmail.com
Columbus, IN
1966 Triumph TR4A
1973 MG Midget
1980 Triumph TR8
2007 Mazda RX8
2002 Yamaha FZ1
2003 Honda ST1300
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>