I just took mine off, in preperation to paint.
Theres the 3 bolts on top of the dash pad.
The two nuts underneath.
I needed to spray the pins underneath that the two nuts came off of with a
very liberal dose of liquid wrench.
Then two of us were able to rock it out.
It wasn't budging before the liquid wrench.
Didn't have to loosen anything else.
Al Salvatore
http://s246.photobucket.com/albums/gg107/6parts/74tr6/
----- Original Message -----
From: "William Brewer" <wsb1960tr3a@att.net>
To: "Triumphs" <triumphs@autox.team.net>
Sent: Sunday, July 12, 2009 11:13 AM
Subject: [TR] TR6 Windshield Frame Removal
> I am stripping my TR6 down for painting. I want to change remove the
> rubber seal between the windshield frame and the scuttle. I loosened the
> two
> nuts that appear to hold the windshield frame on. They are in the outer
> wall
> of the footwell below the windshield frame corners and leading forward at
> about a 30 degree angle. I tried rocking the frame back and forth while
> pulling up and back. This thing won't budge. Is there some secret
> technique
> for getting the windshield frame off? TIA,
> Bill in Tehachapi -getting ready for Triumphest SLO 2009!
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|