Brian,
I am at the same place with my TR3, put new rubber under the doors and now I
can close the doors only with extreme force. Please tell me that after the
3-month period all will be back to normal?
Bill Beecher
'58 TR-3A TS/30766 L (On the road in 2009!)
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Brian Induni
Sent: Tuesday, June 30, 2009 1:52 PM
To: triumphs@autox.team.net
Subject: Re: [TR] door adjustment on TR4
I can tell you that I spent at least 8 hours per door to get them to a point
they would just close. The issue I had was with the new rubber door seals -
they took some squishing down to get the door to close. After getting the
doors close, I lived with it for about 3 months, then readjusted. This time
(yes, another 8 hours per door!) I was able to get them closer. Never did
get the passenger door to where I wanted it.
The doors have limited adjustment and the bolts on the door adjust a
different direction than those on the pillar - but I'm sure you know that. I
did have to use shims that I made from thick (1/8") rubber.
My best advice: patience!
Brian
----------------------------------------------------------------------
Message: 1
Date: Mon, 29 Jun 2009 18:49:05 -0700
From: Mike Katona <mjkatona@gmail.com>
Subject: [TR] door adjustment on TR4
To: "triumphs@autox.team.net" <triumphs@autox.team.net>
Message-ID:
<a210d8520906291849q1f409228hf8109b2d3ae46534@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
Just about pulling the last of the hair I have out.
I cannot get the passenger door adjusted where it will close easily (like
the drivers side).
I have tried setting the striker on the right to the same location as the
left side and it made no difference. Don't think that there is a hinge
issue as the front of the door panel where is meets the body is all in a
line.
The rear end of the passenger door where is meets the body is skewed with
the bottom being flush and the top sticking out about 3/4 to 1".
It just doesn't close solidly.
Is it possible that the striker is bad?
Any suggestions would be appreciated.
Thanks
--
retired, photographer, mule rider, Triumph TR4 driver, lover of life
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as wbeech@flash.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|