Hi all.
I am having no luck removing the cylinder liners from the block. Between
using an air-hammer and a hammer and chisel I have managed to get one liner
up about 1/2 inch above the surface of the block. I thought it would get
easier, but it hasn't. The front of the car is on stands, so I can't get
that good a hammer-swing from the bottom. I am thinking of having someone
weld an old bolt or scrap of metal to the top of the liner and use that to
try to pull it out. I REALLY don't want to remove the engine.
Any ideas?
Thanks,
Kevin
'62 TR3B
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|