I'm adding an oil pressure gauge to the Stag. I'd like to know what material
of flex pipe I should use as the pipe will run very close to the exhaust
manifold. The oil pressure on the stag does not run much above 50-60 PSI
Someone mentioned to use a steel tube to a point away from the manifold and
then branch off using flex pipe.
Any suggestions welcome.
Thanks, Sujit
--
Sujit Roy, Realtor
Keller Williams Realty, Cupertino, CA
(408) 839-8359
roysrealty.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|