On Monday 08 June 2009 03:23:11 pm Angelo Graham wrote:
> Hello Listers:
> Asking about a lube for nylon "bearings" that will not harden and
> crud up the works. Reassembling the foot throttle cross shaft on my
> TR2 and wanted something to put around the nylon button bearing at
> each end of the shaft that would keep things moving smoothly with a
> bit of lubrication. Realize that nylon bearings are not supposed to
> need too much goop, but thought a little wouldn't hurt.
> Thanks for any help you can provide.
>
> Angelo Graham
Angelo,
I just finished installing the front and rear suspensions on my TR6 project and
I used silicone grease for all the bushings. It will not only lube but keep
the water out.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|