My karcher pressure washer gave up the ghost. I discovered that the
little braided copper lead had broken off the carbon rod that forms one
of the motor brushes.
I can't seem to locate anybody selling the brushes, so I was wondering
if I could repair it. I bored a small hole 1/4" into the carbon and
inserted one end of the braid.
The question is; how do I attach the braid to the carbon rod? The
connection has to be somewhat solid and electrically conductive. I was
wondering about liquid solder.
Any experience out in list land?
Cheers,
Mark
1972 TR6
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|