I, too, use homemade cork gaskets. Just use the glass bowl to draw the
outer diameter then sort through your shot glass collection for a suitable
size for the ID.
As I recall I used 1/16" cork because that is what I had but used 2
thicknesses (i.e. 2 gaskets stacked) to make it cushiony enough to get a
good seal w/o excessive tightening. I also used some Blue Hylomar on the
gasket for good measure.
Geo
On Sat, Mar 21, 2009 at 7:30 PM, <pbrandsema@triad.rr.com> wrote:
> What I need to know is where I can get the right type of gasket material.
>
> Paul
> 61 TR4
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|