>The speedo and tach cables have pressed square cross-section ends that are
>nominally 0.125" on each side. The Moss replacements are all oversized by
>more than 0.010", and do not fit completely into the transmission
>recepticle; the corresponding receptacle in the speedo seems to be oversized
>as well and poses less of a problem. The solution is to CAREFULLY grind the
>square ends down to their specified dimension of 1/8" on a side. The
>properly sized end will then enter smoothly and completely into the
>transmission. Forcing the unground ends into the transmission and then
>screwing on the endcap will compress the cable interior and will result in
>fluctuating speedo (or tach) readings, and eventually failure of the speedo.
Margaret at Mo-Ma did mention that I needed to grind the end of the cable off,
so it wasn't too long.B Didn't mention aboutB this, though.B B I can give it
a try.
Thanks, Rick.
Terry
B
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|