triumphs
[Top] [All Lists]

[TR] Wrist Pin Fit

To: <Triumphs@autox.team.net>
Subject: [TR] Wrist Pin Fit
From: "Bob Nogueira " <nogera@worldnet.att.net>
Date: Tue, 17 Feb 2009 19:24:16 -0600
Okay guys, have been assembling my TR-3 engine without a problem until now.
In assembling the rods to the new pistons ( 87mm AE pistons and liners) the
first three had pins that were a light tap with a hammer to install into the
piston. The last is more of a one finger press to insert. Once in place the
first pins are fixed and do not move but the loose one can be made to rotate
with a little effort. Should I start looking for another AE piston or will
this loose fit be okay? IF another piston is needed where would I start
looking?

Thanks for any advise

Bob
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>