Thanks to all, I love this list!!!
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: Bob [mailto:yellowtr@adelphia.net]
Sent: Saturday, January 31, 2009 8:16 AM
To: triumphs@autox.team.net
Cc: Bill Beecher
Subject: Re: [TR] TR3 Rear Apron & Bumperette mounting
On Saturday 31 January 2009 09:02:42 Ed Woods wrote:
> Bill,
>
> If you're speaking about the heavy metal tube immediately surrounding
> the bolt, it was not originally welded. When I reassembled my TR3, I
> installed that tube with heavy grease or never seize so that it would
> not rust to the rear apron. The rear apron itself has a partial metal
> tube of sheet metal into which this heavy walled tube and bolt fit.
> One end of this tube rests solidly against the frame, the other
> establishes the position of the bumperette mounting bracket, so the tube
must be of the proper length.
>
> Ed Woods
Bill,
Ed is correct. The tube is held in place by a long bolt. Nut side towards
the apron.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|