Stan,
That is a very clever way of doing it. Especially the way you used springs
to secure everything. Now I've got 3 designs to think about: the triangles
in the corners, Brian Jones' box that lays on the rear deck and some else
did a box that went vertical against the rear panel.
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
<http://tr6.danielsonfamily.org/> http://tr6.danielsonfamily.org
_____
From: stantr6@comcast.net [mailto:stantr6@comcast.net]
Sent: Tuesday, January 20, 2009 7:50 PM
To: Bob Danielson
Cc: Richard Crabbe; Triumphs@autox.team.net
Subject: Re: [TR] Rear Deck Speaker Plans
Attached photos show how I installed speakers on rear deck of my TR6.
The triangular piece is made from 1/4" plywood I had, the side against the
back panel is slightly curved.
Covered them with padded vinyl from fabric shop, installed t-nuts from rear
for mounting speaker. Fabricated z-clips for bottom of speaker mount, as
well as the fittings in the corner and above speaker that the spring is
attached to. Installed angle alu. as shown, notched to accommodate the
speaker. Speaker mount clips over the angle alu., with the spring holding
the entire assembly in place.
Stan
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|