Hi all
I've purchased all the bits and pieces I need to rebuild the front and rear
suspension of my TR6 and have a question on powder coating.
I have secured a set of poly bushings for the front and back of my TR6 as seems
to be popular even though I understand there is the possibility of the
occassional squek from down under.
I was going to powder coat the front suspension pieces but am wondering if I
need to tape over where the bushings go through. Should these be poly on metal
or poly on powder coat on metal? Bare metal doesn't feel like the right answer
but if it is I'd rather know before the powder goes on! Thanks for any light
that you can shed on this mystery.
While here, what is the best treatment for the rear trailing arsms? I was
going to sandblast to de-stress and either clearcoat or paint. Can anyone
recco a brand/type of paint that has worked for them?
Thanks again!
Steve
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|