> As I
> recall, this is a combination of of an indicator to set float
> height along with two rods that go into the carbs with small
> wires atop them each of which?has a 90 degree bend.? The
> principle appears to be to adjust idle speed until the two
> wires (which each point to the other carb due to the bend)
> are equal and move simultaneously.?
That sounds exactly like the "SU Tool Kit"; which is what I prefer to use
for synchronizing SU carbs when they are mounted in the same plane. But the
SU version doesn't fit ZS carbs (and my ZS carbs are not mounted in the same
plane).
Accuracy does depend somewhat on operator skill; but I feel it's more
accurate than the Unisyn type devices.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|