> Could someone tell me the correct thickness limits of the TR-3 brake
> rotors?
As I recall, there was no clearly defined wear limit given (this was before
the days when such things were required by law). However, the discs are
about .500" new, and the workshop manual says not to remove more than .060",
so presumably .440" is minimum thickness for a rotor to be installed.
However, I've seen people run them much thinner, with no apparent problems.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|