Hi,
I've just wire-brushed my calipers prior to painting. I've done a couple
of sets. One set I seperated 'cause I wound up using a grease gun to get
the pistons out... that was a messy-messy job getting the grease out of
the passages! But the most recent set was a piece of cake (the pistons
came out easily with a screwdriver and some persuasion) and I just used my
bench grinder with 6" wire brushes... the whole job took maybe two hours
(to strip, wire brush and paint), add another hour for painting.
I used Duplicolor silver brake caliper paint.
Regards,
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|