If I were to adjust my accel. pedal thast much lower, I'd never come close
to full throttle. My concern, tho, is not the go pedal, but the ht. of the
brake pedal. It's much lower at rest than the clutch pedal. I've only seen
one other TR6 like that, and I didn't get a chance to speak with the owner.
I take it,Bob, from the work you've done, that the rod connecting the brake
pedal to the booster is not adjustable in length. Too bad. I have no idea
how it ended up this way. I'm determined to work out a way to extend it. Any
ideas appreciated.
Thanks,
Tom
----- Original Message -----
From: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>
To: "'Tom Note'" <tom628@verizon.net>; "'TR List'" <triumphs@autox.team.net>
Sent: Wednesday, October 22, 2008 8:50 AM
Subject: RE: [TR] TR6 Brake pedal height
> On my '75, the clutch & brake pedal are just about dead even. I replaced
> everything that attaches to those two pedals last winter and I can't think
> of any adjustment for them.
>
> The go pedal is a little higher but that was my preference when I
> re-installed it after putting in Art Lipp's bushing kit for the shaft. The
> bracket on the end of the accelerator shaft gives you the option of moving
> the pedal height up or down. You just want to make sure you still have
> 100%
> throttle opening when pushed to the floor.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|