Make one out of flat stock and use the front plate bolts on the left side,
back side of the block casting. Drill a 3/8 hole in it and use a bolt through
the chain. Do the same on the opposite side exhaust manifold stud, rear.
Grind them up neat with a radius on top. File smooth and paint and they are
neat and quite discreet. The lifting eyes had been long removed from my motor.
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************New MapQuest Local shows what's happening at your destination.
Dining, Movies, Events, News & more. Try it out!
(http://local.mapquest.com/?ncid=emlcntnew00000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|